|
TRADE
SHOWS for 2011
Tech Line Coatings, Inc will be exhibiting at
three major shows this year. They are the:
We look forward to seeing many of our customers
there.
CERMAKROME
We have just had independent confirmation that
there is no detectable amount of Hexavalent
Chrome present in cured CermaKrome or related
products. This is important for a number of
reasons related to both health issues and the
requirements of many Manufacturers. Tech Line
has the lowest amount of hex chrome in our
Metallic Ceramic based coatings of any
manufacturer, in an uncured state. This latest
test confirms the superiority of the products in
a cured condition.
COATING THE INSIDE OF
TURBO
COMPONENTS:
The following information was posted by one of
our European Customers on the Discussion Forum
Martelius-Exhaust,
Finland
“We coat the insides of every single turbo
manifold we make with TLHB, it's a significant
help to spool the turbo and an ease of stress on
the tubing material. Also an increasing number
of people want their turbine housings coated on
the inside too. We use the same blasting media
as on the outsides.”
Many have asked about the potential and what
impact on the Turbo it would have. Obviously it
is necessary to make sure the surfaces are
properly prepared. TLHB is a very user friendly
material. Notice how they apply the coating to
the ID of the parts.
"As for the laying of the actual coating,
we block the cylinder head side from the flange
with a rubber seal and some special clamping
tools we have prepared for this. We then fill
the manifold branch by branch from the collector
side, flip it back over and let the coating flow
back out to another container. It's important to
control the position all the time so that no
puddles are left inside.
Below is a photo of a coated manifold and
Turbo by
Martelius-Exhaust .
|
