Tools Needed and Application Procedures For Retail Packaged Products.

• Sandblast with aluminum oxide or fine silica sand. DO NOT USE GLASS BEAD
• Degrease with acetone, lacquer thinner, M.E.K . or similar non petroleum based material
• Spray with an airbrush or detail touch up gun or similar equipment, with fine spray pattern
• Water based coatings spray at 50 to 60 psi; solvent based coatings spray at 35 to 40 psi
• Proper thickness is normally achieved with one wet, solid colored coat
• For those requiring oven curing, most coatings cure between 300f to 500f. For retail packaged products, requiring baking, a standard kitchen oven may be used. SHOP ONLY COATINGS OR SOLVENT BASED COATINGS SHOULD NOT BE CURED IN ANY OVEN COMING IN CONTACT WITH FOOD.
• CERMAKROME may be polished by hand using extra fine steel wool (0000) followed by a polishing compound. For production polishing a vibratory polisher is best, see information on these machines here.

Site design by AndComp Technologies www.andcomp.com
Copyright 2000 Tech Line Coatings, Inc.